3D Viewer

1. Fixed performance when loading fallback well heads locations for wells without perforations in the current timestep when viewing cumulative volumes in FPMap or Bubbles.

GridBuilder

1. Fixed bug with new Max Calculated values defaulted to zero instead of 0.26 (closed packed spheres) for PORO and 1.0 for NTG on existing GridBuilder files.

3D Viewer

1. Icons for grid, wells, slines, fpmap, bubbles in the timestep list are now updated based on the currently selected run even when refreshing.

3DSL

1. Update 3DSL executable and manual to 2021.1031.

Well Data Import Tool

3DSL Enhancements

1. When reading .EGRID/.INIT files and TRANS keywords are not found in the .INIT file, 3DSL will now recompute all connections across faults, pinchouts, and gaps and may generate NNCs.  Previously 3DSL was assuming there were no NNCs for such a grid, unless explicitly defined in the NNCHEAD arrays of the .EGRID/.INIT files.

3DSL Bug Fixes

3DSL Enhancements

1. Reverted a change introduced in V2021.0630 which would reuse the matrix setup when recalling SAMG within a timestep.  The setup is no longer reused when SAMG is recalled.  This may slightly increase runtimes for some models but will avoid excessive runtimes when there are substantial numbers of wells backflowing.  

3DSL Bug Fixes

1. When reading the FAULTS keyword, an out of memory error would occur if a fault contained more than 32,000 separate line entries.

3DSL Enhancements

1. Modified the bulk volume calculation for CPG cells to be identical to studioSL and to Eclispe 100 (See the section CPG Grids – Porevolume Calculation for details).  Note that 3DSL only computes the bulk volume for gridcells if the PORV keyword is not present in a .INIT file.

3DSL Bug Fixes

Grid Builder

floodOPT

1. Updated Windows executable to version 2021.0701.

3DSL simulator

1. Updated Linux executable to version 2021.0730.

Grid Builder

1. When interpolation Zmap points to grid cell properties, ignore null values of the 4 Zmap points that surround the grid cell center point of interest. Only set the grid cell center point of interest to null if all Zmap points are null.  Previously, if any of the 4 points were null, then the grid cell center point was assigned null too.  This will reduce the number of grid cell points that have null values compared to the previous release.

General

1. Fixed possible threading deadlock when using toolpanel controls.